REM615 ABB Motor protection measurement and control device
Delivery time 3 days
Product origin New/used
Email plcru@foxmail.com
Mobile/wechat /WhatsApp +86 18185397189
The EPRO PR9268/017-100 vibration sensor is a device specifically designed to me
The EPRO PR9268/017-100 vibration sensor is a device specifically designed to measure mechanical vibrations. The following is a summary of the main features and details of the sensor:
Main applications:
It is widely used in many fields of industrial measurement, including various turbomachinery, fans, compressors, gear boxes, water pumps, coal mills, etc.
Especially suitable for high temperature environments, such as gas turbines.
Measurement parameters:
Measuring frequency range: 10... 1000Hz and 4... 1000Hz.
Maximum amplitude: up to 3mm (peak-peak).
Provides a voltage signal proportional to the vibration speed.
Technical features:
Rugged construction allows installation in hazardous environments.
The sensor consists of a seismic block and a measuring coil supported by a spring plate that moves axially in the magnetic field of a circular magnet.
When the sensor housing vibrates, a voltage signal is generated that is proportional to the vibration speed.
There are three different sensitivities to choose from, depending on the type of measurement amplifier.
The high output and low impedance of the measuring coil make the sensor have strong anti-interference.
Operating temperature and protection level:
The operating temperature is high, up to 200℃.
Waterproof protection level: IP 55 or IP 65.
Connection and configuration:
Device network port features: The connector type is 5-pin Phoenix connector, the baud rate can be 125K, 250K or 500K, support RS232, 2×RS485/422 and other protocols.
It can be directly connected to the epro MMS 3000 and MMS 6000 turbine monitoring and protection systems.
Packaging and Logistics:
Brand new product, weight about 2KG, packed in good condition.
Sufficient supply of goods can be shipped through logistics channels such as SF Express.
Installation and use:
During installation, properly connect the sensor magnetic base and sensor wire, and attach the sensor to the measuring point of the device under test through the magnetic base.
When installing or removing the sensor, it should be done gently to avoid pulling the connection wire.
